针对部分省市运营商封锁我站网址,模载新启用备用域名18wos.cn
 English
发新主题

[欧卡2/美卡] Liftable Trailer Axles(升降轴拖车)

Liftable Trailer Axles(升降轴拖车)


copy from http://blog.scssoft.com/

Friday, February 24, 2017


Liftable Trailer Axles


We're almost there to release the open betas of the next wave of updates for both Euro Truck Simulator 2 and American Truck Simulator. Let's keep our fingers crossed that we iron out the last few known glitches so that we are able to release the open betas next week.Today we'd like to tease you a little with a glimpse on one of the new features - the implementation of liftable axles for trailers.

This feature was requested by the fan community for quite a while, we're glad to bring it to life for all players looking forward to improvements in simulation fidelity. Lifting a trailer axle allows you to spread the weight among the trailer's wheels to optimize fuel consumption, limit tire wear, or adjust the trailer's maneuverability while turning or reversing. As there was no default hotkey or controller key assigned for this feature as of yet, and we do not want to break players' existing configs, please remember to set this function under any key in the Key & Buttons options.




Stay tuned for more feature reveals as we wrap up the work on the updates. The full change log will of course come along with the actual releases.


翻译重点:这个升降轴模式是模拟现实的车斗都有升降轴以降低在空运输的状态下的油耗量。这项更新将会出现在美卡(American Truck Simulator/ATS)和欧卡2 (Euro Truck Simulator 2/ETS 2)。更新后需要自己配置按键来开启升降模式。推荐按键(本人推荐):Q或N或,或.或/这个更新会在下次更新时推出更新日志将和更新一同推出。

[ 本帖最後由 勇健0818 於 2017-2-25 16:32 編輯 ]



WUY4969 EX RAPID KUANTAN , RAPID KL & RAPID KL (GO KL)


GEMILANG COACHWORK SDN BHD ASSEMBLED BY MASDEF (M) SDN BHD


SCANIA K270UB 4*2LB 8867cc SCANIA DC9 12 270 EURO3 WITH ZF ECOMAT 4 6HP504/C AUTO TRANSMISSION


{NOW IS UNDER MRT FEEDER BUS (JOM NAIK MRT) (OPERATED BY RAPID KL)}


感谢分享了

发新主题
158675&fid=202&action='+ action +'&sid=z3zhuJ'); } else { document.modactions.action = 'topicadmin.php?action='+ action +'&fid=202&tid=158675&page=1;' document.modactions.submit(); } }